Search Results for ‘rear’

Hi there. I have F800GS 2016. I have broke one of the rear signal. Anyone know how to change that ?

i recently acquired a f800gs from 2019. While doing some maintenance, I noticed that one of the rear fairing bolts turns freely inside the frame resting. It seems like the old owner screwed in the bolt too thight, causing the washer to losen up. Any good advise on how to unscrew the bolt?

Hi All, I am looking at replacing the spring in the rear shock. ( '13 F800R ) Can anyone please tell me the relaxed length ( and spring rate if possible ) of the stock spring? Perhaps you have replaced yours and have the original lying about? If so I would be grateful if you could measure...

I just purchased a lowered F650GS Twin (2008) and want to swap to the standard suspension. The part number I'm after is 33537698358. If you'd like to trade for the lowered shock / side stand I can do that, or happy to just buy your standard shock. So if you've got one laying around after an...

Currently running 16 front, 42 rear. Like to run 17 front 45 rear. Cannot find a 45 tooth rear sprocket for the F700GS. Can anyone recommend a source??? Failing that, 47 rear are available, so 18/47 would be acceptable. Can anyone verify that an 18 tooth front sprocket will fit the bike...

Used them since around 2010, when I bought my bike, about 5500mi of mostly highway and some trail riding. This is the model with 8 LEDs/side, and flashes on/off for the first few seconds, then goes solid bright when braking. They work as regular running-lights when no brake is applied. I moved...

I've seen photos of some forum members' bikes, and some of them have a different rear grab handle consisting of a very short loop on either side, rather than the large silver handle which I have on my stock F800ST. I want to change to these cooler smaller grab handles, anyone know where I can...

I've had no problems with my '06 F800s but the spectre of rear bearing failure is on my mind. Is it worth getting the '09 spec axle and bearing fitted as a preventative measure? Any input gratefully recieved! Simon :^)

The stock rear pegs have no grip. My wife was getting on, slipped and scraped her shin. She probably wasn't being careful enough, but the all-metal pegs leave a lot to be desired. Has anyone replaced their rear pegs? It's hard to tell from sites online whether something will fit the F800R...

Can you change the rear brakes without removing the rear tire? I saw the F800Riders video on changing the rear brake pads and the rear tire was removed before the job, as was the exhaust. I just didn't know if that was done to show how to take off the exhaust and rear wheel and get a better...

I've always been a fan of the combination of properly-adjusted Ohlins and the BMW bikes, so after acquiring the 800GS, I took advantage of a generous group buy offer by Kyle Racing and got a rear shock for the new bike. First impressions: 1) Install is *easy*. Remove plastic trim/seat...